What should I do if the screw cannot be turned?
In daily life, it is a common problem that screws cannot turn. Whether it is furniture assembly, electrical appliance repair or car maintenance, you may encounter this situation. This article will combine the hot topics and hot content on the Internet in the past 10 days to provide you with detailed solutions and present relevant tools and methods in structured data.
1. Analysis of the reasons why the screw cannot rotate
The following are the most discussed reasons why screws cannot be turned on the Internet:
| reason | frequency of occurrence | Typical scenario |
|---|---|---|
| Rusty screws | 45% | Outdoor equipment, old furniture |
| Screw slide | 30% | Electronic products that are repeatedly disassembled |
| Screws are too tight | 15% | Newly assembled furniture |
| Screw glue solidifies | 10% | industrial equipment |
2. Practical methods to solve the problem of screws that cannot be turned
According to popular discussions across the Internet in the past 10 days, the following are the most recommended solutions:
| method | Applicable scenarios | Tool requirements | success rate |
|---|---|---|---|
| WD-40 lubrication | rusty screws | WD-40 spray | 85% |
| Rubber band increases resistance | Slide screw | wide rubber band | 60% |
| impact screwdriver | Overtightening the screws | impact screwdriver | 90% |
| Heat gun heating | Screw glue solidifies | heat gun | 75% |
| reverse rotation method | various situations | Ordinary screwdriver | 50% |
3. Tips to Prevent Screws From Turning
Based on advice from DIY enthusiasts and repair professionals, here are the best practices for preventing screws from turning stuck:
1.Regular maintenance: Perform anti-rust treatment on exposed screws every 3 months. You can use anti-rust spray or apply butter.
2.Choose the right tool: Make sure the screwdriver head matches the screw slot exactly to avoid slippage caused by tool mismatch.
3.Control strength: Use a torque wrench to tighten the screws according to the torque value required in the instruction manual to avoid over-tightening.
4.Use anti-loosening measures: Anti-loosening washers or thread glue can be used in important parts, but be careful to choose removable thread glue.
4. Recommendations for popular tools across the entire network
The following are the most discussed screw processing tools on e-commerce platforms and social media in the past 10 days:
| Tool name | price range | Popular index | Main purpose |
|---|---|---|---|
| WOODPECKER impact screwdriver | 120-150 yuan | ★★★★★ | Dealing with overtightened screws |
| 3M anti-rust lubricant | 35-50 yuan | ★★★★☆ | Prevent screws from rusting |
| IRWIN sliding wire extractor set | 180-220 yuan | ★★★★☆ | Remove the sliding screw |
| DEWALT electric impact driver | 400-500 yuan | ★★★☆☆ | Professional maintenance use |
5. Suggestions for handling special situations
1.Guaranteed screws: If the screw has been broken, you can use a special broken screw extractor, or use an electric drill to drill a hole in the section, and then use an anti-thread extractor.
2.Precision instrument screws: When handling small screws in precision equipment such as mobile phones and watches, it is recommended to use a precision screwdriver set and use a magnifying glass to observe the condition of the screws before operation.
3.Important parts screws: For screws in key parts of automobiles, large equipment, etc., if it is difficult to handle them by yourself, it is recommended to seek help from professional maintenance personnel to avoid causing greater losses.
Through the above methods and tools, most problems of screws that cannot be rotated can be effectively solved. Remember, the right approach and the right tools are the keys to success. If you have better suggestions or unique solutions, please share your experience in the comment area!
check the details
check the details
en
